Staff Report Vicinity Map Aerial Photograph Site Plan

No. 01PL119 - Hillsview Estates
A request by Victor Mantei for Canyon Lake Church of God to consider an application for a Layout Plat on Lots 1, 2 and 3, Hillsview Estates legally described as Lot 1 in SW1/4 SW1/4 less Lot H1 & H2, Section 4, T1N, R7E, BHM, Rapid City, Pennington County, South Dakota, more generally described as being located at 1829 Hillsview Drive.

PLANNING COMMISSION RECOMMENDATION:
Planning Commission recommended that the Layout Plat be approved with the following stipulations:

Engineering Division Recommendations:

1.

Upon Preliminary Plat submittal, topographic information identifying the location of existing utilities, shall be submitted for review and approval;

2.

Upon Preliminary Plat submittal, a drainage plan shall be submitted for review and approval;

3.

Upon Preliminary Plat submittal, complete engineering plans as specified in Section 16.20.040 of the Rapid City Municipal Code shall be submitted for review and approval;  

4.

Prior to Final Plat approval by the City Council, the plat shall be revised to show a non-access easement along W. St. Patrick Street, except for the approved approach location.  In addition, a non-access easement shall be shown along the south 128 feet of the west lot line as it abuts Red Dale Drive and along the south 115 feet of the east lot line as it abuts Hillsview Drive;

Register of Deed’s Recommendation:  

5.

Prior to Final Plat approval by the City Council, a revised subdivision name shall be submitted for review and approval.  In addition, the plat title shall be revised to show the approved subdivision name;

Urban Planning Division Recommendations:  

6.

Prior to Final Plat approval by the City Council, a subdivision estimate form shall be submitted for review and approval; and,

7.

Prior to Final Plat approval by the City Council, surety for any required subdivision improvements that have not been completed shall be posted and the subdivision inspection fee shall be paid.

VOTE:  (10 to 0)